HVAC Repair in Mansfield, OH
Homes here need heat from October through May and cooling from June through August. If your system quits, tell us what it's doing and a licensed contractor who covers Richland County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work a year in Mansfield
Your system runs almost year round here. Heat from October through May, then cooling through the summer. Only one month off.
Winter nights average 20°F, cold enough that the furnace cycles on and off for hours through the night. Each start puts a little more wear on the igniter. Summer afternoons reach 81°F, and the air conditioner has to hold that line for three straight months. With so little rest between seasons, worn parts tend to fail right when you need the system most, not in some slow month with nothing riding on it.
Richland County also sees real storms, seven winter storms and 86 damaging wind events over the past ten years. Power has gone out here before. When it comes back on, most furnaces and air conditioners restart on their own. If yours does not, that is worth a call, not a wait.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 20°F
- the average winter night it heats against
- 81°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $190 a year off heating and cooling for a typical Richland County home.
Estimates for a typical Richland County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Ohio fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
In Ohio, HVAC licensing for homes is left to the counties.
Ohio keeps no state license for home HVAC contractors. That decision is left to the counties, so whether Richland County licenses this work, and what its license requires, is what actually stands behind the contractor's name here. Ohio does set one rule that applies no matter the county. A home contractor has to carry at least $250,000 in liability insurance. That is a definition of who counts as a contractor under state law, not a license, and it does not mean anyone tested the contractor's work.
For a repair job like this one, the gas connection is the part that matters most, since a bad connection is the dangerous part of the work. Whether that connection gets inspected, and by whom, depends on what Richland County requires, the same as licensing does. The $250,000 insurance minimum still applies to whoever does this repair, regardless of what the county decides on licensing.
Source: Ohio Legislative Service Commission
- Why is my heat not working?
- Start with the thermostat and the power to the furnace before you assume the worst. Check that the thermostat is set to heat and a few degrees above room temperature, and that its batteries are not dead. Look at the furnace switch, the one that looks like a light switch near the unit, and check the breaker at your panel. If those are fine, the igniter or the flame sensor is a common failure point on gas furnaces. A dirty flame sensor alone can shut the whole system down. Winter nights here average 20°F, so this is not something to leave for a few days.
- Why is my system running but not cooling the house?
- The fan running does not mean the system is cooling. The two most common reasons are a dirty filter and low refrigerant. A clogged filter chokes the airflow across the coil, and when that happens the coil can ice over so the air coming out feels weak or even warm. Low refrigerant means a leak somewhere in the line. That is not something to add to yourself. It has to be found and sealed by a contractor before more is added. Check the filter first since it takes two minutes and rules out the simplest cause.
- What can I check before calling for HVAC repair?
- Check the thermostat settings and batteries first, since a system that looks broken is sometimes just set wrong. Then check the filter and hold it up to a light. If you cannot see light through it, replace it. Check the breaker panel and any power switch near the indoor and outdoor units. A tripped breaker or a flipped switch will stop a system cold with no other symptoms. If the outdoor unit is covered in leaves or debris after a storm, clear it, since it needs open air around it to work. If none of that fixes it, a contractor will need to look at the actual equipment to tell you what is wrong.